Open Access Open Access  Restricted Access Subscription or Fee Access

Improvement of mechanical properties of recycled polyethylene with utilization of bio-filler

Sandeep Rai, Nikhil Patel, Hardik Rana, Sunil Kumar, Anjali Bishnoi, Hitkam Pandya

Abstract


Nowadays, the consumption of plastics all over the world has been tremendously growing, which is culminating into large amount of waste plastic material. It is believed that the management of solid waste is one of the major environmental concerns in the world. Due to limited space on landfills and increasing costs of plastics, utilization of waste plastics has become an attractive alternative for disposal. This research work describes the preparation of composites of the recycled low density polyethylene (RLDPE) with egg shell powder (ESP) as bio-filler. ESP in various loadings (5 to 15 phr) has been utilized in RLDPE composites and its effect on mechanical and thermal properties was observed. Study indicates that as we increase the loading of ESP, tensile strength, modulus of elasticity increases while elongation at beak decreases. Detailed results and future application of this work will be discussed in this paper.

Full Text:

PDF

References


References (follow reference style as below, journal abbreviation must be taken from Chemical Abstract Service, CAS database).

(a) Scientific article

Zare Y. Recent progress on preparation and properties of nanocomposites from recycled polymers: A review, Waste Management 2013, 33, 598-604.

Mangukiya, H.; Rajput,M.; Bishnoi, A.; Rai, S. Functionalization of Reclaim Rubber: Possible Precursor for Polyblends in Engineering Applications. , 2017, 3, (accepted, in press).

Wiedinmyer C.; Yokelson, R.J.; Gullett, B.K. Global emissions of trace gases, particulate matter, and hazardous air pollutants from open burning of domestic waste, Environ. Sci. Technol. 2014, 48, 9523–9530.

Newborough, M.; Highgate D.; Vaughan, P. Thermal depolymerisation of scrap polymers. Appl. Therm. Eng. 2002, 22, 1875–1883.

Bidart, C.; Fröhling M.; Schultmann, F. Municipal solid waste and production of substitute natural gas and electricity as energy alternatives. Appl. Therm. Eng. 2013, 51, 1107–1115.

Jiang, H.Li.; X., Cui, H.; Wang, F.; Zhang, X.; Yang L.; Wang, C. Investigation on the co-pyrolysis of waste rubber/plastic blended with a stalk additive.Journal of Analytical and applied pyrolysis, 2015, 115, 37-42.

Siddiqui, J.; Pandey G. A Review of Plastic Waste Management Strategies. Int. Res. J. Environment Sci. 2013, 2, 84-88.

Datta J.; Kopczyńska, P. From polymer waste to potential main industrial products: Actual state of recycling and recovering. Critical reviews in environmental science & technology 2016, 1547-6537.

Mantia F.P.; Morreale, M. Green composites: A brief review, Composites Part A: Applied Science and Manufacturing 2011, 42, 579-588.

Mousavi, S.M.; Aghili, A.; Hashemi, S.A.; Goudarzian, N.; Bakhoda, Z.; Baseri, S. Improved Morphology and Properties of Nanocomposites, Linear Low Density Polyethylene, Ethyleneco-vinyl Acetate and Nano Clay Particles by Electron Beam. Polymers from Renewable Resources 2016, 7, 135-154.

Oliveira ,G.L.; Costa, M.F. Optimization of process conditions, characterization and mechanical properties of silane crosslinked high-density polyethylene, Materials Science and Engineering A 2010, 527, 4593-4599.

Bashir, A., Manusamy ,Y. Characterization of Raw Egg Shell Powder (ESP) as A Good Bio-filler. Journal of engineering research and technology 2015, 2, 55-60.

Bishnoi, A.; Rai, S.; Kumar, S.; Patel, V.; Kazi, M.; Limbani,A.; Mistry, J. Effect of bio-filler on mechanical and cure properties of reclaim rubber. Journal of Advances in Science, Engineering and Technology 2017, 5, Issue –1(Spcl Iss-3)P-I, (accepted).

Feng, Y.; Ashok, B.; Madhukar, K.; Zhang, J.; Zhang, J.; Reddy, K.; VaradaRajulu, A. Preparation and Characterization of Polypropylene Carbonate Bio-Filler (Eggshell Powder) Composite Films. International Journal of Polymer Analysis and Characterization 2014, 19, 637-647.

Keerthika, B.; Umayavalli, M.; Jeyalalitha, T.; Krishnaveni, N. Coconut shell powder as cost effective filler in copolymer of acrylonitrile and butadiene rubber. Ecotoxicology and Environmental Safety 2016, 1301–3.

Hashemi, S.; Eshghi, A.; Ayrilmis N.; Khademieslam, H. Thermal analysis and Morphological characterization of Thermoplastic composites filled with Almond Shell Flour/Montmorillonite. BioResources 2016, 11, 6768-6779.

Salmah, H.; Marliza, M; Teh, P. Treated coconut shell reinforced unsaturated polyester composites. Intern. Engineer. Technol, 2013, 13920, 94-103.

Salmah, H.; Romisuhani, A.; Akmal, H. Properties of Low density Polyethylene (LDPE)/Palm Kernel Shell (PKS) composites: Effect of Polyethylene Co acrylic acid (PEAA). Thermoplast. Comp. Mater 2013, 26, 3-15.

Shuhadah, S.; Supri, A. LDPE-Isophthalic Acid - Modified Egg Shell Powder Composites (LDPE/ESPI). Journal of Physical Science 2009, 20, 87-98.

Hassen, A. A.; Onat, M. D.; Bansal, D.; Bayush, T.; Vaidya, U. Thermal and Mechanical Characterization of Polypropylene Filled With Naturally Derived CaCO3. Polymers and Polymer Composites 2015, 23,

Murugan, S.; Munusamy, Y.; Muniandy, M.; Ismail, H. Development of HDPE-Modified Eggshell Composite PolymerComposite, 2016.

Hariharan, M.; Varghese, N.; Cherian, A.B.; Sreenvisan, P.V.; Paul, H. Int. J. Sci. Res. Publications 2014, 4.


Refbacks

  • There are currently no refbacks.